Charge RADR, prepare a supported target, scan, connect, and verify low output and Stop in about five minutes.
Outcome: RADR controls the intended target and its pause and Stop actions have been verified without body contact.
Prerequisites
- Charged RADR and charged or powered target
- Target listed in Supported Devices
- Target's own safety instructions
- No phone app or other controller connected to the target
Connect
- Read RADR safety, pause, and Stop and set all outputs to zero.
- Prepare the target with the device-specific guide:
- Move RADR near the target and turn it on. It scans automatically.
- If needed, open the main menu and select Device Search.
- Use the right knob to highlight the exact target name, then press the right button.
- Wait for Device ready! and confirm the expected control screen.
- Without body contact, apply the lowest practical output briefly, then verify Pause and full Stop.
Success
The correct target is named on screen, minimum output responds predictably, Pause stops output, and full Stop leaves every documented output at its safe starting value.
If the target is missing, unexpected, or does not stop reliably, turn it off and use Device scanning or RADR troubleshooting.
Video transcript
The quick-start video demonstrates RADR automatically finding OSSM and a Lovense Domi. It identifies the left speed knob, the right adjustment knob, bumpers, pattern button, and middle pause/Stop button. The written target-specific pages contain the current preparation, low-output, and Stop verification steps.