Power controls
Your Deepthroat Trainer has a power switch on the side of the device. Slide it up to turn the device on.When you power on, the display shows your Trainer ID briefly during boot. You’ll use this for pairing later.
Charge your device
Connect the cable
Plug a USB‑C cable into the port on the top of your Trainer, then connect the other end to a USB power source (wall adapter, computer, or power bank).
Verify charging status on-screen
The display shows charging status when power is connected.
You should see a battery indicator on the screen within a few seconds. If nothing appears, try a different USB‑C cable and/or power source.
%20(1)%20(1)%20(1).webp?fit=max&auto=format&n=LuUTnWrXlgIS5YfY&q=85&s=2f61e36cc57f2583fff69be7c5cf2b84)
Troubleshooting: device won’t turn on
If your Trainer isn’t powering on, work through these steps:Verify your power source
Test the outlet or USB port with another device to confirm it’s delivering power.
Inspect your charging cable and adapter
Look for visible damage on the cable and adapter. If available, try a different USB‑C cable or a known‑good power adapter.
Give it time to recover from a deep discharge
If the battery is fully depleted, it may need time before it can power on. Leave your Trainer connected to power for at least 30 minutes, then try turning it on again.
Check if the device only works while plugged in
If your Trainer powers on while connected to USB but shuts off or won’t turn on after unplugging—even when the screen showed “charging complete”—this indicates a battery issue that requires support assistance.
Need help? Visit Deepthroat Trainer FAQs or email support@researchanddesire.com and we’ll get you sorted out.

