PitClamp Mini Reinforced Standard Base

Assembled PitClamp Mini Reinforced Standard Base showing the complete mount — PitClamp Mini Reinforced Standard Base - Assembled

Printing

Use these standard PitClamp Mini print settings for all components.

Print settings

Setting	Value
Walls	6
Infill type	Cross Hatch or Gyroid
Infill percentage	10%
Supports	Normal (Snug) with 3° threshold angle
Support placement	Allow supports on part
Seam	Nearest (or your preference)

Recommended filament: PLA+ for optimal strength and durability.

All parts must print in the default file orientation. Printing Base components in other orientations causes structural weakness that may lead to failure under load.

Print-in-place option

If your printer is well calibrated and your material has optimal layer adhesion, you can use the print-in-place Upper+Handle variant. Find this in the /Non-Standard folder.

Bill of materials

This BOM is per side—double all quantities for a complete two-sided installation.

Hinge pin hardware

Quantity	Part
1x	M5x20 Socket Cap Screw
1x	M5 Nut

Lever dogbones and handle

Quantity	Part
1x	M4x10 or M4x12 Socket Cap Screw
2x	M4x25 Socket Cap Screw
3x	M4 Nut

Lower reinforced base

Quantity	Part
1x	77x16mm Flat Mending Plate (Straight Braces)
2x	M5x16 Socket Cap Screw
2x	M5 T-Nut

77x16mm plate compatibility: These plates vary between manufacturers. Verify that:

Holes are 5mm diameter to fit the M5 hardware
Outer hole spacing is between 59mm and 61mm

Pre-made kits

If you prefer a complete kit with printed parts and hardware, you can purchase one from the community: